Print Page - Swing Down Galley Replacement Part

Title: Swing Down Galley Replacement Part
Post by: magnmike on Mar 15, 2009, 06:08 PM

Today the sliding metal bar on the swing down galley broke. This is the piece on the bottom side of galley that attaches to the floor and slides in/out when bringing galley up/down. It also serves to cover the hole where the drain pipe slides in and out when brining galley down for travel.

Anyone know where I can get a replacement part?

Title:
Post by: austinado16 on Mar 15, 2009, 07:00 PM

If you have a decent exhaust shop in the area......a shop where you see guys take their street rods and vintage stuff.....go give 'em a tenner to weld it and grind the weld back down smooth.

Good as new.

Title:
Post by: PattieAM on Mar 15, 2009, 08:04 PM

If you don't want to go the weld route, your Fleetwood/Coleman dealership can order the part if not in stock. They may request mode/serial number of your trailer.

Title:
Post by: magnmike on Mar 15, 2009, 08:10 PM

I don't have a dealership close by and was hoping there was somewhere I could order on-line. The part must have gotten bent or hung up as it wouldn't slide back together and then broke the top hinge.

Title:
Post by: tlhdoc on Mar 16, 2009, 06:33 PM

You can contact a Coleman PU dealer and see if they will have Coleman ship it directly to you. I had to replace the same part on my PU a few years back.:)

Title:
Post by: Used 2B PopUPTimes on Mar 17, 2009, 03:36 PM

Call Coleman Camping Trailers' Customer Service - 814-446-9661

Title:
Post by: magnmike on Mar 24, 2009, 03:41 PM

Quote from: PopUPTimesCall Coleman Camping Trailers' Customer Service - 814-446-9661

Update:
Called Coleman parts first. They said I could only order parts through the dealer. I called a local Fleetwood/Coleman dealer. They were able to order it but said Coleman can only ship directly to dealer. I'll have to make a drive out there and pick up when it comes in. Quite expensive part. $65 plus the gas I'll have to spend to pick up as it is a 1 hour trip.

Title:
Post by: tlhdoc on Mar 28, 2009, 08:22 AM

Ask the dealer if they could ship it to you.:)

Title:
Post by: magnmike on Mar 28, 2009, 08:58 AM

Unfortunately I did. They said Coleman only allows them to ship directly to dealer.

Title:
Post by: tlhdoc on Mar 28, 2009, 11:13 PM

After Coleman ships the part to the dealer, I don't know why the dealer won't ship the part to you. Maybe they are trying to get you into the dealership so you will buy more stuff.???

Title: UPDATE to this Thread
Post by: magnmike on Apr 22, 2009, 07:17 AM

Finally got the part from the dealer (remember they wouldn't ship directly to me). The part looks correct, but for the life of me I can't get it to slide apart as it should. It's in the down position. If I can't get it to slide.... then can't connect.... etc. Very frustrating. Anyone have any suggestions.

Title:
Post by: austinado16 on Apr 22, 2009, 09:56 AM

Some pictures would help (me) understand where the problem lies.

PopUp Times

General => General => Topic started by: magnmike on Mar 15, 2009, 06:08 PM