RE: How does your dinnette table attach?

[wssfetch]

 
When you are folding down for travel, how is your dinnette table secured?  Mine slides onto a rail that is screwed to the wall of the camper.  A " short leg"  folds down to support the other end.  The problem I have is that it is really difficult sliding the table onto the rail.  Should I try lubricating with silicon spray or is there another way to attach/support the table that might work better? I don t want to just set it on the floor because it is the perfect height to store plastic storage boxes and the gas grill under and have a lot of space to lay stuff on top for travel and still close slide the bunkends over it.

[missteri]

 wssfetch
Ours just lays on a track attached to both dinette seats.  It s held in place there by velcro.

[mike4947]

 wssfetch
Sue, what you might try is to see if the track will allow the table to fit in the whole length if you angle it way up. Several of my PU s had a track that was wider on the bottom than the top so it would go in all at once. much easier than trying to slide it in from the side.

[GaryWT]

 wssfetch
Curently mine sits between the 3 bench seat.  My old popup had a track it fit in both open and closed.  I had to lift up the opposite end, set it on the track and then lower the raised end.