no heat

[Murr38]

Hello again.
I have a Atwood 7916-11 hydro flame in our Yuma pop up.

Having some problems...
When plugged into the house at home, I connect the LPG, and light the pilot, and then turn on the Thermostat, and raise the heat setting thing, and nothing happens.
No kick in, no action at all.

I tested the gas flow - that is ok.
I also checked the intake and exhaust ports - all clear. (It was stored inside all winter).

No error codes are flashing on the furnace...

Any ideas what I can check before dropping a buncha cash at the Fleetwood dealer?

Thanks in advance.

[coach]

turn the termostat to ON!

atwood troubleshooting BURNER FAILS TO IGNITE AND BLOWER FAILS TO RUN


operating sequence the movie

[austinado16]

turn the termostat to ON!

atwood troubleshooting BURNER FAILS TO IGNITE AND BLOWER FAILS TO RUN


operating sequence the movie

lf turning the thermostat "on" doesn't help, you'll probably need to start checking for voltage at the thermostat.  When mine quit working last year, I removed the thermostat from the wall and discovered a resistor wire inside the back of the thermostat had burned through.

[PattieAM]

It might be as simple as the reset button behind the cover on your furnace.