Wires in tongue frame on 1999 Coleman

[tlhdoc]

I want to attach something to the tongue of my trailer.  The folding tongue jack is on the curb side of the tongue so that side is out.  There are wires that run in the frame on the road side of the tongue.  I have a sway bar toward the front and I would like to put the two screws into the side of the frame behind the ball for the sway bar.  Does anyone know where the wires are located in the frame of the tongue?  Do they just lay on the bottom of the frame?  I don't want to put the screws through the wires.   :confused:

[SkipP]

I want to attach something to the tongue of my trailer. The folding tongue jack is on the curb side of the tongue so that side is out. There are wires that run in the frame on the road side of the tongue. I have a sway bar toward the front and I would like to put the two screws into the side of the frame behind the ball for the sway bar. Does anyone know where the wires are located in the frame of the tongue? Do they just lay on the bottom of the frame? I don't want to put the screws through the wires. :confused:

On both of our Coleman/Fleetwoods, the wires just laid inside the frame attached to nothing except at the ends. I'm pretty sure this is the normal.

[aw738]

When I unpluged from shore power at the ralley I found out that my 12 volt power from the battery wasn't working. After a lot of trouble shooting I ended up replacing the main 12 volt power lead from the battery. All I did was connect the new wire onto the old one and pulled it through the frame. As far as I know nothing is attaching the wires to the frame.

[tlhdoc]

Thanks, I thought it would just lay in there, but I didn't want to put screws in unless I was sure.